- Ev smart card reader writer serial number#
- Ev smart card reader writer install#
- Ev smart card reader writer professional#
- Ev smart card reader writer zip#
Ev smart card reader writer zip#
It is recommended that you secure the shunt using a zip tie if not already done.
Ev smart card reader writer install#
✱ NOTE : Failing to install the shunt in the last IOX could affect IOX communication.
The use of the shunt in the last IOX is necessary for the GO Device to detect and configure the IOX as effectively as possible. That shunt must remain in the last IOX and should be secured with a zip tie. If you are installing more than one IOX in a daisy chain you will need to remove the shunt from each device in line, with the exception of the last IOX connected. You may notice your IOX comes with a termination shunt installed in the expansion port. Note : If the device is not communicating, please ensure the device is installed correctly and try again. If the device is not communicating, the status is displayed in RED text. If the device is communicating, the status is displayed in GREEN text.
Īfter you click Log Install, the web page displayed the current communication status of the device - in GREEN or RED text.
Ev smart card reader writer serial number#
In the space provided, enter your name, the company name, and the GO device serial number - found at the bottom of the device.
Navigate to to verify that the device is communicating. Once your connections to the IOX-AUXM wiring have been made, connect the GO device and immediately start the vehicle. The installation must not interfere with safe vehicle operation. Keep in mind that the location you have chosen for the GO Device will influence the locations available to mount the accessory due to the length of wiring on the IOX-HID. The specification sheets can be found on the HID website through the links in the ‘Supported Readers’ section below.Ĭhoose an appropriate mounting location for the HID accessory. The wires on the IOX-HID are labelled and colours based on their function and the designations are: P1-3 Black (Ground), P1-4 Red (Power), P2-6 Purple (Receive, RX) and P2-7 Green (Transfer, TX). Note: The USB connector can only be inserted in one orientation (see image).Ĭonnect the IOX-HID to the HID RFID Card Reader. Secure the USB connector using a zip tie, being careful not to over tighten it, thereby possibly damaging the USB connector. Plug in the 90° USB connector of the IOX to the GO Device. Remove the IOX expansion port cover on your GO device. Start with the Geotab GO device unplugged from the vehicle. Always read and follow all safety information to prevent loss of vehicle control and serious injury. WARNING! Prior to IOX-HID installation, read and follow Important Safety Information and Limitations of Use, located at the end of the document. Incorrect installation of either the GO device, and/or IOX-HID can result in loss of vehicle control and serious injury. WARNING! Prior to IOX-HID installation, read and follow GO device installation instructions ( goo.gl/rkLRiA ) to verify any existing GO device installation is correct in preparation for IOX-HID installation. Certified Geotab Installer certification or equivalent.
Ev smart card reader writer professional#
✱ NOTE : Professional Installation Required - Installation of the IOX-HID requires the installer to have sufficient technical knowledge and expertise for mobile device installation and integration into modern vehicles, i.e.
G O6 ®, GO7 ®, GO7 RUGGED, GO8 ®, GO8 RUGGED, GO9 ® Male Mini-USB connector connects to the GO Device or another IOX. Male Mini-USB Type-B connector : Daisy chain power & CAN inįemale Mini-USB Type-B connector : Daisy chain power & CAN out
0 kommentar(er)
